Product Info

Page 5/26
2. INTENDED USE OF THE WORK AIR DL001 T U
2.1. Overview
The WORK AIR DL001 T U is an innovative system for the safety of professional workers
working at height, from a height between 1.20 and 2 meters when the user is not connected
to all the anchor points and over two meters when the user is connected to a safe anchor
point with a full-body harness.
The aim is to reduce the risk of injuries caused by a fall without a harness, or swing fall with
impact against an obstacle with a harness following a vertical free fall of at least 1.20 meters.
WARNINGS:
●●● Never use the WORK AIR DL001 T for purposes other than those for which it was
designed.
●●● Never use the WORK AIR DL001 T U when there is a risk of electric arcing and in
ATEX zones.
●●● Never use the WORK AIR DL001 T U when working with tools that could damage
the device, such as angle grinders or soldering irons.
●●● Never use, or switch off the WORK AIR DL001 T U, in the presence of sources of
strong vibrations, such as a jackhammer.
●●● Never use, or switch off the WORK AIR DL001 T U, when driving some types of
vehicles: cars, motorcycles, bicycles, etc... The WORK AIR DL001 T U can be used
and switched on only when using specific vehicles such as telescoping lift platforms
required for working at height.
●●● The WORK AIR DL001 T U does not offer any additional protection in the areas
not covered by the airbag.
●●● The WORK AIR DL001 T U does not offer any additional protection in the areas
covered by the airbag during events that do not cause triggering and inflation of the
airbag.