Product Info

Page 25/26
6. ERROR CODES OF THE DEVICE
For information regarding the main error codes of the System, consult chapter 3.5.3
"Possible malfunctions of the System" of this Informative Note.
7. CERTIFICATIONS
WORK AIR DL001 T U
The Notified Body that certified your WORK AIR DL001 T U is EU NOTIFIED BODY No.
2008 DOLOMITICERT Scarl, Zona industriale Villanova 7/A – 32013 LONGARONE (BL).
002_W
EU:
This electronic device complies with complies with Directive 2014/30 / EU.
USA:
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by DAirlab could void the user's authority
to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC ID: 2AWM3-002W
CA:
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.