Product Info

Page 18/26
3.4. Triggering of the WORK AIR DL001 T U
The sensors installed inside the case of the WORK AIR DL001 T U constantly monitor its
dynamics; information from the sensors is processed by the central unit and, if the values
registered exceed the pre-set thresholds, the System inflates the airbag.
The conditions in which the WORK AIR DL001 T U is triggered are indicated below:
• Without a harness – Vertical free fall from a height of at least 1.20 meters and
subsequent impact with the ground
• With a harness – Vertical free falls from a height of at least 1.20 meters and
subsequent swinging with impact against an obstacle.
WARNING:
●●● This condition for triggering is closely related to the distance between
the anchor point and the position during working activities; in the event of
a fall in which the distance from the anchor point does not permit a vertical
free fall of at least 1.20 meters, the WORK AIR DL001 T U might not be
effective and protect.
WARNING:
●●● The WORK AIR DL001 T U will not be triggered and not protect unless there is a
vertical free fall of at least 1.20 meters.
Triggering time of the WORK AIR DL001 T U varies according to circumstances and the
intensity of the event considered. The air bag is designed to ensure protection for at least 5
seconds after deployment.
WARNINGS:
●●● The events described above are only some examples of triggering conditions. In
some cases included in the aforesaid events, the WORK AIR DL001 T U might NOT be
triggered or might be triggered without being fully inflated before the impact against
an obstacle or with the ground and hence the WORK AIR DL001 T U might NOT
protect, especially in cases in which said events produce a low level of acceleration
that the System is unable to identify as a fall.
●●● In the case of violent events the WORK AIR DL001 T U could be triggered and
hence the airbag could inflate. Therefore, when the WORK AIR DL001 T U is switched
on DO NOT:
• jump, perform acrobatics or particularly sudden movements not normally
performed during normal and correct working practices;
• go down steps higher than 50 cm jumping, or removing both feet from the
ground at once.
• use in the presence of sources of strong vibrations, such as a jackhammer;
• drive vehicles such as cars, motorcycles, bicycles, etc... (only specific vehicles
such as telescoping lift platforms for working at height can be used).
●●● The WORK AIR DL001 T U has an on/off button which allows operation of the
device to be managed and avoids accidental triggering.
●● The WORK AIR DL001 T U has been designed to provide a suitable degree of protection
for 5 seconds after triggering.