Product Info

Page 12/26
2.5. How to choose and wear the WORK AIR DL001 T U
The device must be chosen with attention to the indications and the symbols on the marking.
To choose the correct WORK AIR DL001 T U back and chest protector, refer to the distance
between waist and shoulder, as there is no constant relation with body height.
This is the maximum vertical length, measured at the back, from the waistline to the point in
which the shoulder joins the neck. To find the waistline, stand upright and pass a measuring
tape around your waist 50 mm above the iliac crests.
"Note: 50 mm is an example that refers to a person with a height of 1.78m, this measurement
should be decreased in proportion to the person's actual height; some examples are
indicated in table 4. "
Table 4: Iliac crest distances
Height of wearer (m)
1.56
1.60
1.64
1.68
1.72
1.78
1.82
1.88
1.92
1.96
Distance above the
iliac crests (mm)
44
45
46
47
48
50
51
53
54
55
To find the WORK AIR DL001 T U most suited to the distance between your waist and
shoulder consult Table 5 in the chapter (Position and minimum sizes of the areas protected
by the WORK AIR DL001 T U).
For the recommended correlation between the size of the supports and chest
circumferences, consult the table below:
Size of supports and fasteners
Chest ranges in cm
S
80
92
M
92
104
L
104
116
XL
116
128
In order for a protective device to perform its protective action correctly, the body area to be
protected must remain effectively covered.
The WORK AIR DL001 T U is Personal Protective Equipment provided with its own supports
and fasteners, designed only to be worn over workwear; if used in combination with a
harness, the harness must be worn over the WORK AIR DL001 T U.
Always close the front buckles and adjust the supports and fasteners, ensuring it fits snugly
against the body.
WARNINGS:
●●● Never use the WORK AIR DL001 T U without first having closed all the fastening
systems, in particular fully close the front buckles: it could be dangerous and/or FAIL
TO protect in the event of triggering.
●●● Do not choose too large a size of WORK AIR DL001 T U, as if triggered it could
interfere with the helmet, creating dangerous situations.
●● Always adjust the WORK AIR DL001 T U in such way that it fits snugly against the body.
●● After using the WORK AIR DL001 T U always ensure the device is switched off before
removing it.
● Carefully check the size of your WORK AIR DL001 T U at the time of purchase.
● When choosing the WORK AIR DL001 T U always refer to the distance between waist and
shoulder, as only one size cannot adapt to all body sizes (height and shape).
● The WORK AIR DL001 T U must be considered as personal property.