User`s manual

B) AXC-V25
The AXC-V25 is made from stainless steel and
has been specially designed to ceiling mount up to
4 variant 25A units. This ceiling mount accessory
also allows for hook clamps to be fixed to it, so up
to 4 boxes can be attached to truss structures.
The variant 25A units must be fixed to the ceiling
mount accessory by means of 4 M8x35 DIN912
screws.
Most of the accessories needed to fly or stack
the units are integral to the enclosures. The only
additional items needed are the rigging bumpers.
A) AX-V25
The AX-V25 rigging grid (bumper) is made from
steel beams and is designed to handle great
loads. It features a center reinforcement bar that
is also used for the lifting slings. One chain can be
used to determine the tilt angle of the whole
cluster, depending on the hole used to attach the
chain to the center bar. The first box in the array
will be attached to the AX-V25 by means of the
above described connecting links and quick
release safety pins. All the variant systems can be
attached to the AX-V25 bumper. Up to 20 variant
25A units can be flown from the AX-V25 bumper
while maintaining a 7:1 safety ratio. Up to 6
variant 112A can be flow from the AX-V25 with a
7:1 safety factor.
Weight
Dimensions: 29 x 58.5 x 16.9 cm
(H x W x D) 11.4 x 23 x 6.6 in
: 2.6 kg (5.7 lb)
Weight
Dimensions: 5 x 57.4 x 39 cm
(H x W x D) 2 x 22.6 x 15.4 in
: 5 kg (11 lb)
M8x35 DIN912 screws
The AXC-V25 ceiling mount accessory features
several holes on the top plate which allow for hook
clamps (AXC-AT) to be fixed to them, so up to 4
units can be flown from truss structures.
One slot on each side of the AXC-V25
accessory allows for the setting of the tilt angle of
the whole cluster by means of the M8x35 screws
supplied.
AXC-AT
17
Manual del Usuario / variant / User’s Manual