User manual

57
Problem: The disc will not play once the disc
drawer is closed.
Cause 1:
Disc not inserted correctly.
Remedy:
Position the disc centrally: printed face up.
Cause 2:
Disc soiled.
Remedy:
Carefully clean the disc by wiping with a
soft cloth from the centre to the edge.
Replace the disc and try again.
Cause 3:
Disc damaged in the area of the Table of
Contents (TOC). Disc unusable.
Remedy:
No remedy possible.
Cause 4:
Machine has got very cold (e. g. after
transport), allowing condensation to form
on the laser sensor optics.
Remedy:
Leave the machine to warm up for about
an hour in a warm, well ventilated place.
Problem: Disc stops playing, or 'skips'.
Cause:
Disc dirty or damaged.
Remedy:
Clean disc. Damage cannot be repaired!
Problem:
When used in a non- system the
machine does not respond to remote
control commands, or cannot be
switched on by remote control.
Cause: E 2000 remote control receiver not con-
nected.
Remedy: Connect the E 2000 remote control
receiver as shown in wiring diagram.
Press the source select button 

 /


 on the remote control handset to
switch the machine on.
Problem:
' overheat
overheatoverheat
overheat ' displayed, playback stopped
Cause:
Device is over heated, too little flow of
cooling air
Remedy:
change the installation of your system to
provide sufficient cooling.
do not place the D10 on top of hot equip-
ment like amplifiers or surround receivers
Problem: Not possible to switch to multi channel
mode
Cause:
Disc does not contain a multi channel
layer
Remedy:
no remedy, disc can only be played back
in Stereo.