User manual

42
Creating a MEMO program
Explanation:
A MEMO program can store up to 30 tracks of a CD in
any sequence, e.g. for making a cassette recording. The
MEMO program can only be created for the CD currently
in the machine. It remains stored in the CD player until
either you erase it or you open the mechanism cover.
Procedure:
When you insert the CD the screen displays the message
'STOP' followed by the total number of tracks on the CD.
• Activate MEMO programming.
Hold the 

 button on the incremental control or
the remote control handset in STOP-mode pressed in
until the message 'PROG' appears on the screen,
with a flashing number requesting input.
• Select the desired track by rotating the incremental
control, or by pressing the 

 / 

 buttons
on the remote control handset.
• Now press the 

 button to store the track in the
MEMO program.
The title number flashes once to confirm that this track
has now been accepted as the first track in the MEMO
program. Select all the other tracks you wish to include in
the same way, storing each by pressing the 


button briefly.
Note:
The track you wish to select can also be entered directly
using the numeric buttons of the remote control handset
instead of the 

 and 

 buttons. After entering
a number you can store the track in the usual way by
pressing the 

 button briefly.
When you have stored the 30th track the screen shows
the message 'FULL'. If you enter a further number, the
last stored track - the previous 30th one - will be over-
written.
After you have stored all tracks in the MEMO program,
end the programming procedure as follows:
• End MEMO programming.
Hold the 

 button pressed in for about 1 second
The D10 shows the message 'STORED'. The MEMO-
program is now stored and activated. It can be played by
pressing 

 / 

 button. As long as the MEMO-
program is active the 'P'-symbol on the display is lit.
Playing back a MEMO program
The MEMO program can now be played back.
• Start playback process 

 button
Note:
If you have already created a MEMO program, you can
only use the incremental control and the 

 and


 buttons to select tracks within the MEMO
program.
Erasing a MEMO program
Opening the mechanism cover automatically erases any
existing MEMO program.
A MEMO program can also be erased without opening
the mechanism cover:
• Hold the 

 button pressed in until the message
'CLEARED' appears on the screen. The MEMO
program is now erased and the 'P'-symbol is switched
off.