User Manual

6
7.Power Adjustment
The transmitter output power is divided into two files: high power
transmission (H) = 500 mw; Low power (L) = 100 mw
Shut off power adapter, operate according to the following steps under
transmitter power line cut off condition.
1) Press 【 】 and don’t let go, then connect power(DC12V connected to
transmitter),loosen the key after 3 seconds. Then into power adjustment
status, LCD displays “L” or “H”(picture default as H high power
transmission)
2) Press key【▲】, set it high power file (H).
3) Press key【▼】, set it low power file (L).
4) Select the power file you need, press key【 】again, power setting
completed and it automatically into frequency range setting interface.
8.Frequency Range Setting
1) 1.Frequency band high-end setting: after frequency setting, press key【 】
and into frequency range setting status, LCD displays 108MHz, this
1
Audio input volume adjustment
2
The 3.5 mm audio input hole
2
The power switch button
4
Increasing the frequency
button
5
Frequency decrease buttons
6
The microphone input hole
3.5 mm interface
7
The microphone input
volume adjustment
8
display
9
The 12V 1.67A power supply
interface
10
TNC antenna interface