User`s manual

ROBOT . HEAD to TOE

Product User’s Manual – SD02B

4. After Run is clicked, a window will pop out, following figure show the window.

5. Before any setup can be done, please ensure hardware installation of SD02B is being

setup correctly and power to stepper motor is connected. If you are using UC00A,

UC00A’s driver must be installed.

6. After hardware installation, choose the COM Ports. Normally, the extra virtual COM port

will be the largest number port after driver installation. Select it. The default baudrate for

SD02B is 9600.

7. Click the “Connect” button and SD02B GUI will show “COMxx is connected”.