User`s manual

ROBOT . HEAD to TOE

Product User’s Manual – SD02B

F – A push button acting as reset button to SD02B. If this button is pressed, SD02B will be

reset to initial stage. Please DO NOT pressed this button during operation.

G – A push button to activate self test on SD02B. When it is pressed and hold, SD02B will

start to drive stepper motor. If power supply is connected and voltage selector is

selected correctly, LEDs at C will illuminate sequentially.

H – A small green LED to indicate status of power. If power is connected and voltage

selector is selected correctly, this LED will light ON.

I – Voltage selector to select either Single Supply Mode or Dual Supply Mode for the

power source.

J – A 2510 6 ways connector to power source and/or host. Please refer to chapter 5,

Hardware installation for details.