User`s manual

ROBOT . HEAD to TOE

Product User’s Manual – SC08A

5.2 Connecting SC08A to Computer

One of the main concerns in controlling servo is the hard work needed to get start. However,

with SC08A, getting start is easy as 1 2 3. Since USB was removed from the board, SC08A

offer a UC00A as alternative method to communicate SC08A with PC or laptop. With

UC00A, no RS232 (serial port, DB9) is needed. This will save tremendous work and time.

Simply plug UC00A to SC08A and (PC or Laptop), driver will installed automatically (1

time user only) and there is an extra virtual COM port. Only power source for servo motor is

needed if SC08A is connected to PC. Anyway, the power of UC00A is isolated from the 5V

pin (external supply).

1. Simply connect UC00A to SC08A and PC/laptop as shown in following figure. The

driver will installed automatically (1

time user only) and there is an extra virtual

COM port.

2. Connect servo power source at JP2(blue terminal block). SC08A get it power from

UC00A.

Connect to PC or

laptop