User Manual


ROBOT.HEADtoTOE
ProductUser’sManual–MDDS60


6.MOTORCONNECTION

Similar to the power supply, connection to the motor can be made either via the terminal               
block,oritcanbesoldereddirectlytothebottomlayerpad.

For Mixed mode, especially for RC input mode (or Breakout board with Joystick soldered),             
each terminal block must be connected to the same side of the motor. For example, left               
terminal block connected to motor LEFT and right terminal block connected to motor            
RIGHT. User can further test it by controlling the motor by using RC controller. If the motor                
givewrongdirection,reversethepolarityofthemotorconnectionattheterminalblock.


 

CreatedbyCytronTechnologiesSdn.Bhd.–AllRightsReserved 10
