Cytron SmartDriveDuo Smart Dual Channel 10A Motor Driver : Manual : Page 12

ROBOT . HEAD to TOE

Product User’s Manual – MDDS10

connection before powering up.

8. INPUT MODE

When the SmartDriveDuo-10 is powered up, RUN-L LED, ERR LED and RUN-R LED will

running once. After that, the input mode will be read from the DIP switch and retained as

long as the driver is powered. If you wish to change the input mode, you will need to change

the setting on the DIP switch and press the “RST” reset button, or power cycle the driver

(Turn it off and turn it on again).

SmartDriveDuo-10 supports four different types of input mode (RC, Analog, PWM and

Serial). The DIP switch settings for each mode and the function for input pin are summarized

on the following page.

*You can find DIP switch setting and other information at the back of SmartDriveDuo-10