Data Sheet

ROBOT . HEAD to TOE

Product User’s Manual – Shield-Servo

E – UART communication between Shield-Servo and PC’s Serial

Communication Interface (SCI).

F – A push button acting as reset button. If this button is pressed, Shield-Servo will be

reset to initial stage. Please DO NOT pressed this button during operation

G – A push button to activate self test. When it is pressed and release, Shield-Servo will

start to drive Servo motor.

H – A small green LED to indicate status of power. If power is connected and voltage,

this LED will light ON.

I – Voltage input for the power source.

J – 10/8/6 ways arduino header to host. Please refer to chapter 5, Hardware installation

for details.

K _ Need to solder if want to use power from Arduino or Supply power to Arduino using

single power supply.