Specifications

INSTALLATION Cyrus III Amplifier
English
6
Connecting a Turntable
Connect the phono cable from the turntable to the phono
input - PH
8
. Be sure to follow colour coding of the
plugs to keep left and right channels correctly ordered. If
the turntable has a ground wire fitted, connect this to the
Turntable ground connection
13
of the amplifier.
Note that the phono pre-amplifier of the Cyrus III is
suitable for use with a pick-up cartridge of either moving
magnet or high output moving coil design. A low output
moving coil cartridge will require a step-up transformer or
pre-amplifier to be used externally. Your dealer can advise
if this is necessary.
Connecting other Inputs
Connect a phono cable between each system component
and the rear panel sockets as marked on the rear panel
diagram. At all times observe the colour coding of the
phono cable for left and right channel identification. The
Cyrus III provides for connection of a CD Player -CD
7
,
a tuner - TU
9
, a video recorder or video disc player - VI
10
,
and an auxiliary input - AU
6
.
The AU input can be used for connection of a wide variety
of products such as a second CD player, tuner or VCR, an
electronic keyboard, an organ or a second tape deck if
only replay is necessary. Always check the technical
specification of these products before connecting to your
Cyrus III. Consult your dealer if in doubt.
Connecting a Tape Recorder
Two phono cables are necessary for connection of a tape
recorder when used. Firstly, connect a phono cable from
the Output or Playback sockets of the tape recorder to the
Tape Input - TP IN
5
of the Cyrus III. Then connect a
second phono cable from the Input or Record sockets of
the tape recorder to the Tape Record Output - TP OUT
4
sockets of the Cyrus III.
Connecting Loudspeakers
The left and right loudspeakers are connected to the rear
panel sockets
1
and
2
of the Cyrus III respectively
using the plugs provided. First, fit the plugs to the
loudspeaker cables. Carefully note that the cable carries
marking or colours for polarity, (+ and -) may also be
marked for direction with an arrow. For correct operation,
it is essential that the (+ and - ) terminals of the amplifier
are connected to the corresponding
(+ and -) terminals of the loudspeakers. When fitting the
plugs to the cables be sure to line up (+ and -) at each end.
The loudspeaker plugs can now be fitted to the amplifier
sockets.