Specifications

Cyrus III Amplifier INSTALLATION
5
English
The Cyrus III may be positioned as a free standing unit or
alongside another piece of audio equipment. Never stand
the Cyrus III under another unit. This may adversely affect
the efficient cooling of the Cyrus III. Never place the
Cyrus III on a carpet or similar material which may
hamper normal ventilation.
The Mains Supply
The moulded IEC connector of the mains lead supplied
should be plugged in to the power inlet
14
on the rear of
the unit.
The mains fuse
15
is located on the rear panel next to the
power switch. It must only be replaced with the following
types:
U.K. / Europe - 230V T1A/20mm
N. America / Far East - 115V T2A/20mm
In the U.K., the Cyrus III comes with the mains plug
fitted. In the unlikely event that the plug fuse should need
replacing ensure that it is only replaced with a 3 Amp
Fuse.
IMPORTANT
NOTE TO USERS OF PSX-R WITH CYRUS III
In order to use a PSX-R regulated power supply with the
Cyrus III Amplifier, certain internal adjustments must be
made to the Cyrus III which can only be carried out by
an authorised Mission distributor or his agent.
Connection of the PSX-R to a Cyrus III which is not
correctly adjusted will result in fault condition display
on the Cyrus III. The Cyrus III fault indication system is
fully described in the Cyrus III handbook.
Connecting a PSX-R Power Supply (Optional)
If a PSX-R is to be used with the Cyrus III, proceed to
connect the umbilical cord of the PSX-R to the 5-pin
Cannon input socket of the Cyrus III. When correctly
fitted, the connector will latch into place in the socket.
Note that when a PSX-R is in use, both the PSX-R power
supply and the Cyrus III will require mains power.
Note:
For more details on the PSX-R, please refer to the Cyrus
PSX-R Instruction Manual.
POSITIONING THE UNIT
CONNECTING THE UNIT