Specifications

CY3280-SmartSense CapSense Auto-Tuning Kit Guide, Doc. # 001-64672 Rev. *A 17
Load CapSense Example Projects
Figure 3-5. Output Window
3.1.3 Program Project
1. Open Program Part in PSoC Designer by selecting Program > Program Part
2. In the Program Part window
a. Select MiniProg3 in the PortSelection box
b. Set Acquire Mode to Power Cycle. If the board is already powered from AAA batteries or
from external supply through J2, set Acquire Mode to Reset
c. Set Verification to ON. This ensures that downloaded checksum matches actual checksum
d. Set Power Settings to 5V
e. Click program arrow to program the device
3. Wait until programming is complete
4. Disconnect MiniProg3 from kit