User`s manual
Table Of Contents
- Stellaris® LM3S9B96 Development Board Overview
- Stellaris® LM3S9B96 Development Board Hardware Description
- Stellaris® LM3S9B96 Development Board External Peripheral Interface (EPI)
- Using the In-Circuit Debugger Interface
- Stellaris® LM3S9B96 Development Board Schematics
- Stellaris® LM3S9B96 Development Board Component Locations
- Stellaris® LM3S9B96 Development Board Connection Details
- Stellaris® LM3S9B96 Development Board Microcontroller GPIO Assignments
- Stellaris® LM3S9B96 Flash and SRAM Memory Expansion Board
- References
January 12, 2010 41
Stellaris® LM3S9B96 Flash and SRAM Memory
Expansion Board
This document describes the Flash and SRAM memory expansion board
(DK-LM3S9B96-EXP-FS8) plug-in for the DK-LM3S9B96 development board. This expansion
board works with the External Peripheral Interface (EPI) port of the Stellaris microcontroller and
provides Flash memory, SRAM, and an improved performance LCD interface.
Figure E-1. DK-LM3S9B96-EXP-FS8 Board Image
Installation
To install the expansion board on the DK-LM3S9B96 development board, do the following:
1. Remove the DK-LM3S9B96-EXP-FS8 memory expansion board from the antistatic bag.
2. On the DK-LM3S9B96 board, remove any installed board on EPI connector J2.
3. On the DK-LM3S9B96 board remove the shunt jumpers on JP16-JP31 and the JP39 headers
as shown in Figure E-1 on page 41.
APPENDIX E