Datasheet

MT-X1S Manual

Appendix B: Other MattairTech Products

ZeptoProg II AVRISP mkII Programmer

●

● AVRISPmkII compatible AVR Programmer

● Supports all AVRs with ISP, PDI, or TPI

● Optional 5V output via headers to target board, with

standard jumper and PTC fuse

● 4-channel Logic Analyzer

● Serial bridge / pattern generator / SPI interface

● GPIO / PWM / frequency input & output

● Atmel Studio / AVRDUDE support

● Target board voltage of 2V to 5.5V via level-shifted

pins on two main headers

MT-DB-U6 USB AVR development board

●

● AT90USB646 / AT90USB1286 USB AVR

● 64KB/128KB FLASH, 4KB/8KB SRAM

● 5V, 500mA LDO regulator (3V-30V input)

● Auto power source selection IC (USB/External)

● 16MHz and 32.768KHz crystals

● Arduino compatible

● CDC or DFU bootloader

MT-DB-X4 USB AVR XMEGA board

●

● ATxmega128A4U USB XMEGA AVR

● 128KB FLASH, 8KB SRAM, 2KB EEPROM

● 3.3V LDO regulator (low quiescent current)

● 16MHz and 32.768KHz crystals

● LED, boot jumper, PDI header

● Reset button, mounting holes

● USB DFU bootloader preinstalled

MT-D21E USB ARM Cortex M0+ board

●

● ATSAMD21E17A or ATSAMD21E18A (32-pin)

● 128KB/256KB FLASH, 16KB/32KB SRAM

● Onboard 3.3V, 250mA LDO regulator (2uA quiescent)

● 16MHz and 32.768KHz crystals

● USB connector (power by USB or external up to 15V)

● Blue LED, 10-pin Cortex header, 2 buttons, I2C

pullups

● USB Mass Storage Bootloader (no programmer

required)

January 29, 2015 36 http://www.mattairtech.com/