Datasheet

MT-X1S Manual
FLIP
Plug in the MT-X1S with jumper JMP installed and while holding down the PROG button. This
will enter the DFU bootloader. LED_STS should be on and LED_PWR should be off. Now launch the
FLIP utility. When it has loaded, click on the chip icon and select the AT90USB162.
Next, click on the USB icon, select USB, then connect. The screen should now show
information about the AT90USB162. Click on the File menu, and open the appropriate hex file. More
information will appear about the program. Be sure that erase is checked. The MT-X1S firmware
cannot be loaded unless the flash is erased first. Program must be checked. Verify should also be
checked. Now click on the Run button in the lower-left of the screen, and the firmware will be quickly
loaded onto the MT-X1S. If you encounter problems, you will need to unplug the MT-X1S, disconnect
FLIP, and start over making certain that the above settings are observed.
January 29, 2015 29 http://www.mattairtech.com/