Datasheet

MT-X1S Manual
Firmware Updates
Firmware Updates
The MT-X1S firmware will be updated periodically to add new features and fix bugs. These
updates will be available on the MattairTech website. The updates may include just a hex file (for
programming flash), or both a hex file and eep file (for programming both flash and EEPROM). FLIP is
a graphical utility for Windows used to load firmware updates onto the MT-X1S. FLIP includes the
DFU bootloader driver. Download FLIP 3.4.2 or higher from http://www.atmel.com/tools/FLIP.aspx and
install. If required to install a signed driver, then consult the table below for the download link.
Downloads required for Firmware Updates
Software Version Driver URL
MT-X1S
Firmware
latest
(At90USB162)
N/A http://www.mattairtech.com/software/MT-X1S/MT_X1S.hex
FLIP 3.4.2 + DFU driver http://www.atmel.com/tools/FLIP.aspx
Signed DFU
Driver
latest DFU driver
http://www.avrfreaks.net/index.php?module=Freaks
%20Academy&func=viewItem&item_type=project&item_id=219
6
Once FLIP is installed, the DFU bootloader driver can be loaded. Plug in the MT-X1S with
jumper JMP installed and while holding down the PROG button. This will enter the DFU bootloader.
LED_STS should be on and LED_PWR should be off. Windows will then prompt you for the
AT90USB162 driver. By default, this is located in the Program Files/Atmel/Flip 3.4.2/usb directory.
Once the driver is loaded, the device will appear as the AT90USB162 device under Atmel USB
Devices in the device manager (note that ATmega32U2 is shown in screenshots).
January 29, 2015 28 http://www.mattairtech.com/