Datasheet

MT-X1S Manual
Next, select the Fuses page. It is best to leave the fuse settings alone until you understand
what they do. In particular, do not set the BOD (Brown-out detection) voltage too close to 3.3V, as this
could cause the target to be held perpetually in reset. Due to errata, the BOD should not be enabled in
sampled mode when active or idle (BODACT). Sampled mode is OK for other sleep modes (BODPD).
Now you may wish to look at the other pages. Note that any firmware upgrade feature should
not be used. The MT-X1S PDI Programmer is not an actual AVRISP mkII, it just emulates one, so you
should not attempt to update the MT-X1S firmware using Atmel Studio. Any firmware updates will be
posted to the website and loaded using FLIP or dfu-programmer.
January 29, 2015 22 http://www.mattairtech.com/