Specifications

① Power: Press to turn ON/OFF the system.

② ID: Press transmitter “ID” button and receiver “ID” button for 2 second to pair

the system. These systems already paired before exit factory hence, user

don't need to reset it again unless the system can’t up link probability. Press

the ID button for more than 10 second to switch to different mode

(Broadcast/Unicast). Green power LED means switch to Unicast mode and

Red power LED means switch to Broadcast Mode. The factory default is on

Unicast mode and it is suggested to use this modefor household using. It is

not necessary to press both transmitter and receiver's ID button in the same

time.

③ IR sensor.

④ Power: The LED will illuminate when power ON.

⑤ Link: For pairing and learning the LED will flashing speedily, during the signal

link stage the LED will flashing slowly. When LED illuminate without flashing it

means the signal link probability.

4.2 Receiver side

4.2.1 Front Panel

4.1.2 Rear Panel

① HDMI 1/2/3 Inputs: Connect each of the input ports to the HDMI output

of your source equipment such as DVD player or set-top-box.

② Power: Plug the 5V DC power supply into this unit and connect the

adaptor to AC wall outlet.

1 2

HDMI3

HDMI2

HDMI1

DC 5V

1 2

PowerIR Link

Power

CWHDI-RX Receiver