Specifications

13
R SHARPNESS Inquire sharpness setting
S NR 0~3 Noise reduction setting
R NR Inquire noise reduction
setting
OFF(0) / LOW (1) /
MIDDLE(2) / HIGH(3)
S AUDIODELAY 0~3 Audio delay setting
R AUDIODELAY Inquire audio delay
setting
OFF(0) / 40ms (1) /
110ms(2) / 150ms(3)
S AUDIOMUTE 0/1 Audio mute setting
R AUDIOMUTE Inquire audio mute
setting
ON(0) / MUTE(1)
S SDIAUDIO 0~3 SDI Audio CH setting
R SDIAUDIO Inquire SDI audio
CH setting
CH1CH2(0), CH3CH4(1)
CH5CH6(2), CH7CH8(3)
S AUDIOSELECT 0/1 Audio input setting
R AUDIOSELECT Inquire audio input
setting
Analog (0)
Optical (1) at CV, SV,
YPbPr, PC
S KEY LOCK 0/1 Key lock setting
R KEY LOCK Inquire key lock setting
ENABLE(0) / DISABLE(1)
FW Firmware checking
S RESET 1 Pre-reset
S POWER 0/1 Power Setting OFF (0) / ON (1)
R POWER Inquire Power Setting
EXIT Exit
1) iJL command must first be insert before starting using RS-232
command to control the device. This command is CASE-SENSITIVE.
Other RS-232 command will be not executed unless followed with a
CR+LF (Carriage Ret + Line Feed) and commands are CASE-
INSENSITIVE.
2)Audio delay supports only on analog L/R output.
3)When HDMI input is with HDCP, PC/HD will output no image.
4)Digital Audio supprts LPCM 2CH only therefore, please ensure source
input audio is sending LPCM 2CH's audio signal in order to
avoidunceccessary audio noise.