User`s manual

10 Chapter 2: Installation
Calorimetry Sciences Corp.
CSC 5300 N-ITC III 11
User’s Manual
5300 icon located on the desktop or by going to Start⇒Programs⇒CSC 5300. After
the software starts set the temperature to 25.0°C and let the system equilibrate for
approximately 1 hour to allow the internal electronics to warm up.
Select the “Monitor” tab to display the virtual strip chart. Heat readings (μJ/sec) slowly
scroll across from the right side of the screen. The N-ITC III is now ready for use.
Reinstalling Software
The software for your N-ITC III was previously installed at the factory. However, a set of
software installation disks are included in the event you need to reinstall the software.
1. Insert N-ITC III software CD in the CD-ROM drive.
2. Select Start⇒Run.
3. In the Run dialog box type D:\Setup.exe, or browse to locate the appropriate setup
le, and click OK.
4. Follow the on-screen prompts as indicated.
5. When the software installation process is complete, a prompt may appear indicating
you need to restart your computer. If this prompt appears then software installation is
not complete until you restart your computer system.
Installation of the N-ITC III software is now complete.