User manual
3
2. Picture: Press the button to toggle through picture adjust parameters as follows:
ContrastBright Color Hue Detail Contrast
* Contrast: Press or to adjust contrast level. The range of adjustment is 0~63.
Factory default value is 58.
* Bright: Press or to adjust Brightness level. The range of adjustment is 0~63.
Factory default value is 31.
* Color: Press or to adjust color level. The range of adjustment is 0~63.
Factory default value is 31.
* Hue: Press or to adjust NTSC Hue level. The range of adjustment is 0~63.
Factory defaults value is 31.
* Detail: Press or to adjust Detail level.
The range of adjustment is 0~63. Factory defaults at 10.
3. , : Press to toggle through various adjust controls or to alter setting value.
4. Source/Input Selection: Press one of the four input buttons allows manual selection
of the corresponding video source signal.
* Video: Press this button to select the Composite Video source and the built-in
yellow led will illuminate when it's selected.
* S-Video: Press this button to select the S-Video source and the built-in yellow led
will illuminate when it's selected.
* YPbPr: Press this button to select the Component Video (YCbCr or YPbPr) source
and the built-in yellow led will illuminate when it's selected.
* PC: Press this button to select the PC source and the built-in yellow led will
illuminate when it's selected.
5. Output Resolution Selection: Press one of the four output buttons allows manual
selection of the corresponding output resolutions.
- When the "6" buttion is illuminated, press to select desired PC output resolutions for
VGA, SVGA, XGA or SXGA.
- When the "6" buttion is off, press to select desired HDTV output resolutions for 480p,
576p, 720p or 1080i.
* VGA/480p: Press this button to select either VGA or 480p output resolution and
the built-in red led will illuminate when it's selected.
* SVGA/576p: Press this button to select either SVGA or 576p output resolution and
the built-in red led will illuminate when it's selected.
* XGA/720p: Press this button to select either XGA or 720p output resolution and
the built-in red led will illuminate when it's selected.
* SXGA/1080i: Press this button to select either SXGA or 1080i output resolution and
the built-in red led will illuminate when it's selected.
6. Output Format Selection: Press to select desired output format for either PC or HDTV
output. Press once will turn on the built-in red led when
the PC output has been selected by pressing the button.
Press again to select the HDTV output and the built-in led
will turn off.