Specifications

2
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Transmitter Front and Rear Panels
ERROR
HDMI LINK
HDMI
INPUT
OPTICAL
LINK
OPTICAL
DC 5V
1
2
3 4 5 6
1
HDMI LINK
This blue LED will illuminate when at least one optical cable is
connected and has successfully detected and sent, between the
Transmitter and Reciever, a signal containing video or audio data.
2
ERROR
This red LED will illuminate when there appears to be an error in the
input signal data rate that is higher than 75MHz or the HDMI output
signal is not compatible.
3
HDMI INPUT
Connect to an HDMI input source such as a DVD or Blu-ray player
with a HDMI cable.
4
OPTICAL LINK
This blue LED will illuminate when the optical cable is connected
and has successfully detected and communicated data between
the Transmitter and Receiver.
Note: If the LED is not illuminated then users will need to check
the connection of the ber cable between the Transmitter and
Receiver units and then check the connection is good and that
the cable itself is correct and undamaged.
5
OPTICAL
Connect the Transmitter and Reciever units with ber optical cable
to transmit the data signal.
Note: Connector Type: LC-LC, Fiber: Duplex Multi-mode Fiber
6
DC 5V
Plug the 5V DC power supply into the unit and connect the
adaptor to an AC outlet. The LED will switch on when the power
cable is plugged in.