Specifications
8. Remote Control
①
Power: Press this button to turn ON/Standby the system.
②
1~0: These numbers buttons are for output and input
port selection buttons. First select your desire output
port (01~08) follow by input port (01~08) and press
enter. Example: when users wish to select output 1 to
display input source 2 then users will need to press
0102 + enter buttons. The green LED on top of the
entry button in the front panel will blink when users
push these buttons.
③
Enter: Press this button every time after your selection.
If this button is not pressed after 5 second, the selection is avoid.
9. IR Pin Assignment
9.1 IR Receiver
9.2 3.5Ø Connectors Pin Denition
POWER
CR-71
ENTER
①
③
②
①
IR signal
②
Power 5V
③
Grounding
① ② ③
Pin Assignment
1 Power 5V
2 IR Signal
3 GND
7