User manual

4. CV-IN: Use a Composite video cable to connect the composite video
output of the source equipment to this composite video(CV) input
of the scaler.
5. S-Video: Use a S-Video cable to connect the S-Video output of the
source video equipment to this " S-Video" input on the back of the video Scaler.
S-Video provides improved performance over composite video and is
recommended over composite.
6. PC/HD output: This HD-15 D-Sub connector is shared by PC/RGBHV output
and HDTV/YPbPr output.
When PC/RGBHV output resolution (VGA to SXGA) is selected,
use the HD-15 to HD-15 VGA cable to connect this output to the PC input
of your display monitor.
When HDTV/YPbPr output (480p, 576p, 720p, pseudo 1080i) is selected,
use the HD-15 to YPbPr 3 x RCA cable to connect this output to
the YPbPr input of your HDTV display.
Note: Use of wrong cable for your selected output will result in an abnormal
picture on the screen.
(5). OSD Operation:
After power on the unit , press the Menu button to bring up the main menu
page as below:
Main Menu
Input Source
Picture adj.
Output Setup
Exit
Main Menu
INPUT SOURCE PICTURE ADJ OUTPUT SETUP OTHERS
SCART 1
SCART 2
COMPOSITE
S VIDEO
BRIGHT
CONTRAST
COLOR
TINT
SHARP
RESET
TIMING
VGA
SVGA
XGA
WXGA
SXGA
480P
576P
720P
Pseudo 1080i(540p)
OSD SETUP
OFF
AUTO
SCREEN COLOR
BLUE
GREEN
BLACK
Use +,- button to move "V" to your desired parameter, then press MENU/ENTER
to enter into sub-menu of your selected parameter.
Input Source:
Select Input Source and press MENU/ENTER to enter into Input Source submenu.
Use +,- button to move "V" to your desired input source. Press MENU to
confirm your selection.
Picture Adjust
When Picture Adjust is selected a sub menu as below appears.
Default Range
BRIGHT
CONTRAST
COLOR
TINT
SHARP
RESET
Exit
32
32
32
16
03
0-64
0-64
0-64
0-32
0-8
3