Specifications

© 2010 Cypress Solutions Complete Manual: CTM-15X Firmware 1.3.0
Open CTM (Revision D)
96
Command Reference
OK
2. Query the existing dialup emulation PAD client port
cmd padclientport
cmd padclientport 5006
OK
A cmd save is required for this command to take effect.
See also: pad, padecho, padesc, padesct, padfwdc, padfwdl, padfwdt, padip, padmode, padport,
padreset, padsvct
return to list of commands
padecho n
Sets the PAD echo mode – if echo is enabled then all data sent to the modem on its RS232 port by an
external device is echoed back to that device.
n = 0 PAD echo mode: disabled
n = 1 PAD echo mode: enabled (default) The current PAD echo mode can be queried by using the
padecho command without parameters.
Examples:
1. Disable the PAD echo – characters received on the modem’s RS232 port will not be echoed to the
connected device
cmd padecho 0
OK
2. Query the current PAD echo setting
cmd padecho
cmd padecho 1
OK
A cmd save is required for this command to take effect.
See also: pad, padesc, padesct, padfwdc, padfwdl, padfwdt, padip, padmode, padport, padreset, padsvct
return to list of commands