Specifications

Open CTM (Revision D)

Command Reference

return to list of commands

gpsremport n xxxxx

Sets the IP port number of the remote server that the GPS report will be sent to.

Up to 8 GPS reports can be configured.

n = 1 to 8 or 11 GPS report number

xxxxx = 0 to 65535 remote port number in decimal

The current IP port configuration for a GPS report can be queried by using gpsremport n where n is the

report number.

If n is omitted, all reports will be queried.

Examples:

1. Report #1 will be sent to port 5005 on remote IP address set by gpsremip

cmd gpsremport 1 5005

2. Query the remote port setting of all GPS reports

cmd gpsremport

cmd gpsremport 1 7001

cmd gpsremport 2 4114

A cmd save is required for this command to take effect.

See also: gpsrep, gpsdelmes, gpsaddmes, gpsremip, gpsremport, gpsemail, gpssms

return to list of commands

gpsrep n l r s

Sets the reporting type for each GPS report for the local and remote servers.

n = 1 to 8 or report 11 GPS report number

l = 0 disables local GPS report (default)

l = 1 asynchronous NMEA or ULCP messages over RS232

l = 2 asynchronous NMEA or ULCP messages with a ULCP header over RS232

l = 3 in-band NMEA or ULCP messages in a UDP Packet over Ethernet