Specifications

© 2010 Cypress Solutions Complete Manual: CTM-15X Firmware 1.3.0
Open CTM (Revision D)
41
Command Reference
datareport [r1] [r2] [r3] [r4] [r5] [r6] [r7] [r8]
This command sets the report(s) to be used for link data count triggered events.
See data and datacond for information on configuring the link data reports.
Where:
r = 0 disables the report
r = 1 to 999 report number
Examples:
1. Use report 2 for link data count triggered reports.
cmd datareport 2
OK
cmd datareport
cmd datareport 2 0 0 0 0 0 0 0
2. User report 1, 2 and 4 for link data count triggered reports.
cmd datareport 1 2 4
OK
cmd datareport
cmd datareport 1 2 4 0 0 0 0 0
OK
3. Disable link data count triggered reports
cmd datareport 0
OK
cmd datareport
cmd datareport 0 0 0 0 0 0 0 0
OK
See also: datacond, repaddmes, repdelmes, repemail, replocport, repremip, repremport, repsms, reptype
return to list of commands
dir pppppppppp [qqqqqqqqqq]
This command sets the NAM (Number Assignment Module) value for the modem. It is a 10-digit phone
number assigned to the modem by the service provider. Use the spc command to unlock the modem first.
The NAM value may be queried by using the dir command without parameters.
This command also sets the MIN (Mobile Identification Number) value for the modem. It is a 10-digit
number assigned to the modem by the service provider. Use the spc command to unlock the modem first.