Specifications

Open CTM (Revision D)

Command Reference

cmd confupgrade ctm15x-config.sh http://cypress.bc.ca where ctm15x-config.sh is the script file, and

cypress.bc.ca is the HTTP server

cmd confupgrade action.sh localhost://tmp will execute the script /tmp/action.sh on the modem

cmd confupgrade action.sh localhost will execute the script /etc/config/action.sh on the modem

return to list of commands

ctm15x

This command is used to enable a reset of protected configuration values.

Current protected configuration commands are:

cmd data

cmd ethernet

cmd enghours

cmd odometer

cmd ctm15x must be run once prior to setting any of the above configuration values.

cmd ctm15x is volatile and cannot be saved, its state will be reset following a modem power cycle or

reboot

See also: data, ethernet, enghours, odometer

return to list of commands

8.1.4 “D” Commands

data [0]

This command keeps track of the amount of data transmitted and received over the wireless data link.

The total data transmitted and data received counts can only be reset by using the following command:

cmd data 0

0 Set to 0 to reset

The current amount of data transmitted and received can be queried using cmd data without

parameters, the result is shown in megabytes (MB).

A cmd factory does not reset the wireless link count statistics of this command.