Specifications

© 2010 Cypress Solutions Complete Manual: CTM-15X Firmware 1.3.0
Open CTM (Revision D)
181
ULCP Remote Configuration Messages
2
bytes
Maximum report time: sets a timer to send reports if the unit has not moved the set distance
2
bytes
Minimum report time: sets a minimum time between reports
1 byte
Control flags:
Bit 0 is used to make time based reporting active: 1 = active; 0 = inactive (switch off the start-up
reporting)
Bit 1 is used to save this configuration to NV memory, but currently not supported: 0 = do not
save; 1 = save to NV memory.
Bit 2 is used to select the report destination IP address:
when bit2 is 1 = use the IP address(destination UDP Port number) configured above;
when bit2 is 0 = use the IP address(fixed UDP Port number 6101) of this incoming setup
message.
Bit 3 is used to select the message mode: 1 = ASCII mode (no ULCP header); 0 = with ULCP
header
1 byte
Number of messages to report
8
bytes
Message list: up to 8 messages may be specified. Refer to the above list of possible messages
If the command was not successful then no response is sent.
Response header: 0x56 0xSS 0x03 0x00 0x00 0x18 0xNNNN
Where NNNN is the password.
Response message body: the message body as defined above
Query
Request header: 0x56 0xSS 0x00 0x00 0x00 0x00 0x0000
Request message body: None.
If the command was not successful then no response is sent.
Response header: 0x56 0xSS 0x01 0x00 0x00 0x18 0xNNNN
Where NNNN is the password.
Response message body: the message body as defined above
12.2.9 Download Script Files
Request header: 0x5E 0xSS 0x02 0x00 0x00 0xLL 0x0000
Where 0xLL is the length of the message body.
Request message body: