Specifications

© 2010 Cypress Solutions Complete Manual: CTM-15X Firmware 1.3.0
Open CTM (Revision D)
179
ULCP Remote Configuration Messages
12.2.5 ULCP Binary Position Query
Request header: 0x55 0xSS 0x00 0x00 0x00 0x00 0x0000
Request message body: None.
If the command was not successful then no response is sent.
Response header: 0x55 0xSS 0x01 0x00 0x00 0x18 0xNNNN
Where NNNN is the password.
Response message body:
Refer to Message Type 85 ULCP binary format GPS data message GPSULCPP0S.
12.2.6 Wireless Link Data Count Query
Request header: 0x5C 0xSS 0x00 0x00 0x00 0x08 0x0000
Request message body: None.
If the command was not successful then no response is sent.
Response header: 0x55 0xSS 0x01 0x00 0x00 0xLL 0xNNNN
Where LL is the length - dependent on the Modem ID string length, NNNN is the password.
Response message body:
Refer to Message Type 92, ULCP binary format, Wireless Link TX/RX Data Count with Modem ID
ULCPLINKDATACOUNT.
12.2.7 Time Based Reporting
Setup
Request header: 0x57 0xSS 0x02 0x00 0x00 0x18 0x0000
Request message body:
Hex
Description
4
bytes
Report destination IP address: xx.xx.xx.xx If 0.0.0.0 is set then use the IP address of this incoming
setup message
4
bytes
Report source IP address (the modems IP address): xx.xx.xx.xx
2
bytes
Report destination UDP Port number. If 0 is set then use the port number of this incoming setup
message
2
bytes
Report source UDP port number: set to 6100
2
bytes
Report time. Range 1 to 65535 seconds. 0 disables time based reporting
1 byte
Control flags:
Bit 0 is used to make time based reporting active: 1 = active; 0 = inactive (switch off the start-up
reporting)
Bit 1 is used to save this configuration to NV memory, but currently not supported: 0 = do not