Specifications

Open CTM (Revision D)

140

Command Reference

See also: mode, reptype, repremport, repremip, replocport, repemail, repsms, repaddmes

return to list of commands

syslog n

Provides a mechanism to retrieve the log of system events recorded by the modem.

Log events include network connects and disconnects.

Note that the system log is stored in volatile memory so it will be lost when power is cycled on the

modem.

n = 0 to 65535 number of system log records to return. Leaving n blank will return the entire contents of

the system log up to a maximum of 65535.

Examples:

cmd syslog 10 returns the last 10 events stored in the system log

cmd syslog returns all events stored in the system log

return to list of commands

8.1.16 “T” Commands

telnetport n

Sets the port for telnet access (both local and remote).

A cmd save and power cycle is required for this command to take effect.

n = 1 to 65535 port to be used for telnet (default: port 23)

The current telnet port setting can be queried by entering telnetport without parameters.

Firmware version R1.2.1 and below: When the telnet port is changed using telnetport from within a

local/remote Telnet session, this session will be disconnected. To complete telnet port configuration, you

will need to reconnect to the telnet server at the new telnet port, issue a cmd save and power cycle.

Firmware version R1.3.0 only: To complete telnet port configuration, power cycle the modem.

Example:

1. Set telnet port to 33