Specifications

© 2010 Cypress Solutions Complete Manual: CTM-15X Firmware 1.3.0
Open CTM (Revision D)
131
Command Reference
cmd enghours
cmd data
The below commands are not supported in either showconfig or showstate commands. To configure
these commnands the showconfig script file or input text must be manually updated.
cmd factory
cmd ratesel
cmd telnetpswd
Commands can be manually entered as shown in the output of showconfig using the syntax shown. The
showconfig output can be 'Copy & Pasted', if there is a long list list of commands, it is recommended to
use a telnet session rather than the serial console to capture the output of showconfig.
Example:
cmd showconfig returns the current modem configurations
return to list of commands
showstate
Returns the current state of the modem.
This is a read only command.
showstate returns the modem state:
firmware revision
modem ESN
modem ID
modem IP address
odometer
engine hours
RF Switch output mode, 0 = RF device connected or connecting, 1 = RF device off, awaiting switch
input.
SMS destination number
SMS text
amount of data transmitted and received over the wireless data link
Example:
# cmd showstate
Firmware Version:CTM15x R1.2.2 (rev. 1483)
ESN:09604890958
Modem ID:09604890958
Modem IP Address:96.1.3.13
Odometer:0 KM