Specifications

© 2010 Cypress Solutions Complete Manual: CTM-15X Firmware 1.3.0
Open CTM (Revision D)
124
Command Reference
2. Send report #2 as an SMS message to the specified email address
cmd repsms 2 [e-mail]
OK
3. Query the SMS destination for report #1
cmd repsms 1
cmd repsms 1 1234567890
OK
4. Query the SMS phone numbers or email addresses for all reports
cmd repsms
cmd repsms 1 1234567890
cmd repsms 2 [e-mail]
OK
A cmd save is required for this command to take effect.
See also: repaddmes, repdelmes, repemail, replocport, repremip, repremport, reptype
return to list of commands
reptype n l r s
Sets the reporting type for local and remote servers.
Note: SMS features are only available for specific manufacturer, RF modules, cards or devices. Please
contact Cypress Solutions for a complete list of products that support SMS functionality.
n = 1 to 999 report number
l = 0 disables local report (default)
l = 1 asynchronous NMEA or ULCP messages over RS232
l = 2 asynchronous NMEA or ULCP messages with a ULCP header over RS232
l = 3 in-band NMEA or ULCP messages in a UDP Packet over Ethernet
l = 4 in-band NMEA or ULCP messages with a ULCP header and in individual UDP packets over Ethernet
l = 5 in-band NMEA or ULCP messages in a TCP Packet over Ethernet
l = 6 file-based reports
r = 0 disables remote report (default)
r = 3 in-band NMEA or ULCP messages in a UDP Packet
r = 4 in-band NMEA or ULCP messages with a ULCP header and in individual UDP packets