Specifications

Open CTM (Revision D)

Installing Your Modem

IMSI has been downloaded

PRL has been downloaded

During updating, if any of the data is unsuccessful, the "OTASP Timeout" message and "OTASP

Disconnected" message will be displayed. A progress message reading "OTASP Processing" will be

displayed every 10 seconds. When the OTASP process has successfully completed and the provisioning

parameters have been committed, a message "OTASP Disconnected" message will be displayed.

2.3.2 Manual Activation

At # prompt, type the following commands:

cmd spc pppppp where pppppp is the 6 digit lock code

cmd dir nnnnnnnnnn where nnnnnnnnnn is the 10 digit MDN phone number

cmd pwrmode 2 power cycle the modem

The MIN entry is provided to add support for Wireless Number Portability (WNP) and also needs to be set

on the modem by entering the following commands:

If no MIN is provided use the MDN number provided.

cmd spc pppppp where pppppp is the 6 digit lock code

cmd dir + nnnnnnnnnn where nnnnnnnnnn is the 10 digit MIN number

cmd pwrmode 2 power cycle the modem

3 Installing Your Modem

1. Mounting

The CTM-15x is provided with a flexible mounting bracket that has eight 5mm mounting holes suitable for

#10 screws. These may be used to screw or bolt the device to a suitable surface – take care not to over-

tighten these screws and damage the bracket. Once this has been installed in the required location the

modem clips into the 4 tabs of the bracket. The bracket can be used as drill guide template. There are a

total of 8 mounting holes, (2, 4 hole patterns, 2 x 5.5 and 1.75 x 3.75)