Specifications

Open CTM (Revision D)

116

Command Reference

ratetmr n

Sets the required network rate test timer of the device. This is used to configure the modem to test for an

available EV-DO network while it is in a 1xRTT connection.

This command is valid for Sierra Wireless CDMA/EV-DO data devices and modules only.

n = 0 disable the timer (default)

n = 1 to 65535 time in seconds. Note that time in second is an approximate value; the time between

periods will be greater than the “n” value set

The current timer setting can be queried by entering the ratetmr without parameters.

Examples:

1. During a 1xRTT connection the modem will disconnect approx. every 120 seconds and then reconnect

on the EV-DO network if available, otherwise it will reconnect on the 1xRTT network

cmd ratetmr 120

2. Query the current network rate test timer setting

cmd ratetmr

cmd ratetmr 120

A cmd save is required for this command to take effect.

return to list of commands

repaddmes n x [x2][x3][x4]

Adds a message type to a report. 4 messages can be included in a single report. Duplicate messages

cannot be included in a report.

Messages will be sent in a report in the same order that they are added.

ULCP header messages will be sent as individual UDP packets – NMEA format messages will be combined

into a single UDP packet.

n = 1 to 999 report number

x message type to be added, valid message types must be used - see message list

The messages associated with a single report can be displayed by using the repaddmes n command. If n is

omitted, the messages associated with all configured reports will be displayed.

Examples:

1. Add message type #16 – GPS NMEA GLL – to report #4