Specifications
© 2010 Cypress Solutions Complete Manual: CTM-15X Firmware 1.3.0
Open CTM (Revision D)
115
Command Reference
cmd pwrwoe 1 60 c 0
OK
4. QUery the current configured parameters for wake on event
cmd pwrwoe
cmd pwrwoe 0 0 10 0
OK
A cmd save is required for this command to take effect.
return to list of commands
8.1.14 “R” Commands
ratesel n
Sets the required network rate mode (CDMA vs. EV-DO) of the device. This command is not valid for
GSM/GPRS/HSPA devices.
Note:
Prior to using the cmd ratesel command, use cmd mode to verify that the modem is in manual
connection mode=1. Otherwise, use cmd mode 1 to put the modem in manual connection mode.
The ratesel command talks directly to the embedded card/module and does not require cmd
save for the setting to be saved.
Entering cmd ratesel without parameters will return an “ERROR”, this is normal operation.
ratesel is valid for Sierra Wireless CDMA/EV-DO data devices and modules only
The Sierra Wireless AC580 (EV-DO revision 0, Cardbus device) only supports ratesel n = 2
n = 0 1xRTT only
n = 1 EV-DO only
n = 2 Auto Rate Select (hybrid mode) - default
Example:
Set the network rate mode to 1xRTT only
cmd ratesel 0
OK
return to list of commands