Specifications

© 2010 Cypress Solutions Complete Manual: CTM-15X Firmware 1.3.0
Open CTM (Revision D)
110
Command Reference
Provide the connected device a PPP connection through the serial port.
After the modem is powered up, enter the cmd ppp command and disconnect from the terminal
program.
Use a Windows Dial Up Network (DUN) connection to connect to the modem. Use #777 as the dial
string/phone number for the serial PPP connection.
To escape from this mode and return to the command line, type EXIT in the terminal program.
Use cmd mode 3 to put the modem into permanent PPP mode.
When the modem is configured for PPP mode, the IP addresses used in the serial PPP connection will use
the same subnet as the modem's Ethernet LAN IP, after configuring using cmd lanip, cmd apply, cmd
save, and a power cycle. For example, if the modem was configured with a LAN IP of 192.168.6.1, the
serial PPP connection will use 192.168.6.200 and 192.168.6.202 as the IP addresses for the serial PPP
client and the modem, respectively.
When using cmd mode 3 or cmd ppp, the modem's DHCP server IP pool, configured using landhcp, must
not include the range x.x.x.200 - x.x.x.202.
Example:
1. Start the modem into PPP mode
cmd ppp
OK
See also: landhcp, lanip, mode
return to list of commands
pswd n
Sets the password used for wireless network access via simple IP. This is often set to the electronic serial
number (ESN) of the modem.
n a maximum of 40-character alpha-numeric username
A save operation is required.
Examples:
cmd pswd 12345678900 sets the password to 12345678900
cmd pswd displays the current password used for wireless network access via simple IP
A cmd apply followed by a cmd save are required for this command to take effect.
See also: mip, user
return to list of commands