Specifications

© 2010 Cypress Solutions Complete Manual: CTM-15X Firmware 1.3.0
Open CTM (Revision D)
102
Command Reference
2. Query the current PAD mode
cmd padmode
cmd padmode 1
OK
A cmd save is required for this command to take effect.
See also: pad, padclientport, padecho, padesc, padesct, padfwdc, padfwdl, padfwdt, padip, padport,
padreset, padsvct
return to list of commands
padpfc x
Sets the PAD postfix character that is added at the end of each packet. Default = none (disabled)
x = none Disabled. No character is added to the end of a PAD packet.
x = 1 to 255 PAD forwarding character representing an ASCII character.
The current PAD forwarding character can be queried by using the padpfc command without parameters
Examples:
1. Set the PAD postfix character to ASCII <LF>
cmd padpfc 10
OK
2. Query the current PAD postfix character
cmd padpfc
cmd padpfc none
OK
A cmd save is required for this command to take effect.
See also: pad, padecho, padesc, padesct, padfwdc, padfwdl, padfwdt, padip, padmode, padport,
padreset, padsvct
return to list of commands