Specifications

Open CTM (Revision D)

Activating Your Modem

For all other manufacturer data devices and cards, network activation of the device must be done in a

laptop prior to installing in the modem.

2.1.2 GSM/GPRS/HSPA devices

For GSM/GPRS/HSPA devices, the following information is required:

An activated SIM card needs to be installed in the Modem or data card

cmd factory gsm must be entered

Note: TRU-install™ must be disabled on devices that support the TRU-install™ feature prior to

installation into the modem, or activation will not be successful

2.2 Embedded Web Page Activation

Note: Activation via the modem Embedded web browser is supported only on Sierra Wireless AC595,

AC597 Express Card, AC597/8 USB and AC580 data devices with the TRU-install™ feature disabled. For all

other devices, activate the device using a laptop

2.2.1 Automatic Activation via Modem Embedded Web Browser

On the OTASP (Over-The-Air Service Provisioning) page, click Initiate to start the OTASP processing,

depending on the programming data on the modem card, one or more of the following messages will be

displayed on the OTASP page’s status window:

SPL Unlocked

Authentication key has been updated

Shared secrets data has been exchanged

New NAM parameters have been downloaded

New MDM has been downloaded

IMSI has been downloaded

PRL has been downloaded

During updating, if any of the above data is unsuccessful, the "OTASP Timeout" message and the "OTASP

Disconnected" message will be displayed. To retry the OTASP process, click Initiate to re-start. When the

OTASP process is complete and the provisioning parameters have been committed the "OTASP

Disconnected" message will be displayed.

Click Initiate and cycle the power on the modem.