Specifications

AAddaapptteerr BBooaarrddlleett SSiiddee 11:: WWaannddCCaamm
Side 1 of the snap-out boardlet contains an adapter that
supports the connection of an Avnet WandCam OV5640
MIPI CSI-2 camera to the Agate I/O Breakout Cable.
Any MIPI CSI-2 one to four lane camera that is compatible
with the WandCam standard can be supported. Referring to
the diagram below, the FPC (left hand) connector is linked
to the WandCam via a short length of 0.5mm pitch FPC
cable. The right hand connector links to the Agate cable.
This is actually a Mini DisplayPort connector, which we use
because it is a perfect signal match for MIPI CSI-2, for
which there is no standard connector.
connector to
YUV camera
connector to Agate
FPC socket
connector to Avnet
WandCam MIPI
CSI-2 camera
connector to
Agate I/O cable
Side 2 of the snap-out boardlet contains an adapter that
supports the connection of an 8-bit high resolution
OV5640Y to an 24-pin FPC connector located mid-board on
the Agate.
Referring to the diagram below, the FPC (left hand) connec-
tor is linked to the camera via a short length of 0.5mm pitch
FPC cable. The right hand connector links to the Agate.
The Agate connector supplies 3.3V to the boardlet.
Regulators on the boardlet derive 2.8 and 1.5V for the cam-
era and apply them to the YUV camera connector
Figure 8: WandCam Adapter Boardlet
Figure 9: YUV Adapter Boardlet
page 9
Figure 7: Avnet WandCam Front and Back Views
AAddaapptteerr BBooaarrddlleett SSiiddee 22:: YYUUVV DDiiggiittaall CCaammeerraa