Specifications

CY8CKIT-042 PSoC 4 Pioneer Kit Guide, Doc. # 001-86371 Rev. *D 99
Advanced Topics
4. Ensure that MiniProg3 is the selected port in PSoC Programmer and the 10-pin connector (10p
option) is selected, as shown in the following figure. If the board is not powered over USB, select
the Power Cycle programming mode.
Figure 6-50. Select MiniProg3
5. When ready, press the Program button (or File > Program) to program the PSoC 5LP device.
6. After programming has completed, the following message appears: “Program Finished at
<time>”.