User guide

8 CY8CKIT-002 MiniProg3 User Guide, Doc. # 001-59350 Rev. *E
Introduction
1.3 Debugging
MiniProg3 supports the following debugging protocols for 8-bit and 32-bit PSoC devices:
■ SWD (PSoC 3, PSoC 4, PSoC 5LP)
■ JTAG (PSoC 3, PSoC 5LP)
■ I
2
C (limited PSoC 1 devices)
The MiniProg3 debugger is supported by the software tools PSoC Creator and PSoC Designer.
1.4 Bridging
MiniProg3 supports USB-I
2
C bridging protocols. These protocols are used for debugging certain
PSoC 1 devices that support serial communication debugging, tuning, and configuration of fixed
function devices. The MiniProg3 bridging capabilities are used by PSoC Designer, PSoC Creator,
PSoC Programmer, Bridge Control Panel, and other applications. Tuning software tools also use
these capabilities.
Note If you want to develop your custom USB-I
2
C applications using MiniProg3, see the PSoC
Programmer COM guide and examples of the custom USB-I
2
C applications.
1.5 Document Revision History
1.6 Documentation Conventions
Table 1-1. Revision History
Revision
PDF
Creation Date
Origin of
Change
Description of Change
** 09/19/11 WBZ/RAVG Initial Release.
*A 11/01/11 WBZ/RAVG
Safety Information section added. Appendix A Troubleshoot-
ing guide updated
*B 5/10/12 ANDI/LRDK
Information about accuracy and resolution of measured volt-
age added to Power section
*C 08/28/12 AESA Updated template and changed installation path
*D 10/10/12 RRAM Reorganized the Appendix section
*E 03/25/13 SASH
Updated Table 2-1 on page 11. Added PSoC 4 and PSoC 5LP
device
Table 1-2. Document Conventions for User Guides
Convention Usage
Courier New
Displays file locations, user-entered text, and source code:
C:\...cd\icc\
Italics
Displays file names and reference documentation:
Read about the sourcefile.hex file in the PSoC Designer User Guide.
[Bracketed, Bold]
Displays keyboard commands in procedures:
[Enter] or [Ctrl] [C]