Specifications

54 CY3214-PSoCEVALUSB Kit Guide, Doc No. 001-67030 Rev. *B
Code Examples
5.2.4 Verify Output
1. Load the Example1.hex from <Install_Directory>:\Cypress\CY3214-PSoCEVAL-
USB\<version>\Firmware\ButtonsAndLights\PSoC Project\Example1, as
explained in Programming Specifications and Connections on page 16.
2. On successful programming, disconnect the MiniProg1 and connect the board to PC.
3. Open the Buttons and Lights GUI (Example1.exe) from
<Install_Directory>:\Cypress\CY3214-PSoCEVALUSB\<version>\Firmware\But-
tonsAndLights\PC Software\Example1.
4. Press any of the four soft buttons on the GUI; the corresponding LEDs in the GUI glow (green)
and similar LEDs glow in the kit (red).
Figure 5-42. (a) GUI Display (b) Kit Display
Figure 5-43. (a) GUI Display (b) Kit Display
(a)
(b)
(a) (b)