Specifications

48 CY3214-PSoCEVALUSB Kit Guide, Doc No. 001-67030 Rev. *B
Code Examples
- Port Selection: select MiniProg1/<MiniProg Number> with the status Connected
- Acquire Mode: Power Cycle
- Verification: Off
- Power Settings: 5.0 V
c. Click on the Program button to start programming the board.
d. The programming starts and the status is displayed on the progress bar.
Figure 5-31. Programming Status
e. When the programming is done successfully, the 'Operation Succeeded!' Message is shown.
Figure 5-32. 'Operation Succeeded!' Message
5.1.4 Verify Output
1. Make the following connections on the board using the single strand jumper wires provided.
a. Connect 2-KΩ resistor between Port P0.5 (P05 on J4) and P1.5 (P15 on J9).
b. Connect LED1 to Port P3.1 (P31 on J10) and LED2 to P3.2(P32 on J10).