Specifications

CY3214-PSoCEVALUSB Kit Guide, Doc No. 001-67030 Rev. *B 47
Code Examples
Figure 5-29. Connect MiniProg1 to Board
38.The board can be programmed either through PSoC Designer IDE itself or by launching PSoC
Programmer.
39.To program the board using PSoC Programmer, see PSoC Programmer on page 14.
40.To program the board through PSoC Designer, follow these steps.
a. Click on Program > Program Part.
Note When programming the board from PSoC Designer, close any open instance of PSoC Pro-
grammer.
Figure 5-30. Program Part Window
b. In the Program Part window, configure the following settings: